Tsurumi 100AB2.4(S) 4" 1/2HP 1/3-Phase SUBMERSIBLE PUMP

Featuring a cast iron propeller, 4" discharge, and can pass solids up to .315". A great pump for irrigation and waterways where high head is not a priority.

• Axial Flow, cast iron propeller provides for high efficiency, high volume pumping at low head

• Highly efficient, continuous duty air filled, copper wound motor with class E, insulation minimizes the cost of operation

• Built in thermal protection prevents motor failure due to overloading, accidental run-dry and single phasing in three phase units

• Double inside mechanical seals with silicon carbide faces, running in an oil filled chamber and further protected by a lip seal running against a replaceable, 430 stainless steel shaft sleeve, provides for the most durable seal design available

• Double shielded, permanently lubricated, high temperature C3 ball bearings rated for a B-10 life of 60,000 hours provide for extended operational life

• AB Series has non toxic White Mineral Oil

• Anti-wicking block keeps motor protected from water damage even when insulation is compromised

• Dual inside silicon carbide mechanical seal

• Single or three-phase operation, 110V

• Capacitor start

Applications:
Residential, commercial, industrial wastewater and site drainage
Decorative waterfalls and fountains
Raw water supply from lakes or rivers
Tail Water Pump